Headlines
Flo torque hub
- Thread starter ROGUE
- Start date
bbladesprops
Sponsor
Theoredically yes. Square insert in square hole. It's been so long I'd actually have to do the measurement myself but memory says yes it works even though it is a little sloppy.
Brett
Brett
ROGUE
Charter Member
I used the steel inserts with the rubber corners and it went in quite tight. hehe. Ive had a plastic insert in one of my props for 10 years and never hurt it but I am pushing a bit too much hp through that so bought the steel ones this time.
Ive never had any luck with redone rubber inserts, they usually let go quite soon and were expensive. Glad they came out with the hubs. Of course that doesnt do any of my old round hub props any good.
Ive never had any luck with redone rubber inserts, they usually let go quite soon and were expensive. Glad they came out with the hubs. Of course that doesnt do any of my old round hub props any good.
bbladesprops
Sponsor
Put grease on the rubber snubber strip prior to putting them in and your world is much easier!
When prop shops rehub the rudder hubs, they need to hone the bore prior to the re insert. This will help but, your right, re hubbing the round bores are never as good as the original.
Brett
B
When prop shops rehub the rudder hubs, they need to hone the bore prior to the re insert. This will help but, your right, re hubbing the round bores are never as good as the original.
Brett
B
Similar threads
