Wayne Pennell
New member
Looking for a used IMCO shorty if anyone has one available. I need it to be 1.5 gears....Thanks
Headlines
WTB..2" IMCO Shorty
- Thread starter Wayne Pennell
- Start date
Wayne Pennell
New member
Thank You........'04 25 Baja Outlaw, 496 HO....looking to add Stellings box this year with shorty.
I live in Flushing....near Flint.
Ratickle
Founding Member / Super Moderator
Sweet. PM Smittyseng on "25' Baja peformance advice if you need to. Look at his "How fast is your Baja thread".....:sifone:
Wayne Pennell
New member
drpete3
New member
But did you see that Paul has mucho posts? Some guys have over 20K:willy_nilly:
Im here everyday
Ratickle
Founding Member / Super Moderator
SOmebody has to keep an eye on the Doc......:sifone:
Wayne Pennell
New member
Anyone?
Teague Custom Marine
Sponsor
Complete new lower!!
Hey Wayne,
We have your answer! I can build you the strongest "XR" lower w/ a IMCO -2" satin case w/ any choice of gear ratio for $5,157.25 ready to install. We Use the IMCO Case, Mercury Gear sets (1.5:1, 1.35:1, 1.26:1), TCM verticle Shaft, TCM Prop Shaft, TCM Carrier, and the good bearings! You are also going to need a S.S. cav. plate. Our drive techs have been building drives for high HP for 10+ years, and know and understand the correct set-up.
Beware of the used lowers. If you do buy one, sent it to a reputable company who builds and serivces these drives to have it gone through. Chances are you are going to be replacing parts before you even use it, which could easily cost more than a new one! -Eric
Hey Wayne,
We have your answer! I can build you the strongest "XR" lower w/ a IMCO -2" satin case w/ any choice of gear ratio for $5,157.25 ready to install. We Use the IMCO Case, Mercury Gear sets (1.5:1, 1.35:1, 1.26:1), TCM verticle Shaft, TCM Prop Shaft, TCM Carrier, and the good bearings! You are also going to need a S.S. cav. plate. Our drive techs have been building drives for high HP for 10+ years, and know and understand the correct set-up.
Beware of the used lowers. If you do buy one, sent it to a reputable company who builds and serivces these drives to have it gone through. Chances are you are going to be replacing parts before you even use it, which could easily cost more than a new one! -Eric
