Water pressure gauge

[dykstra]

New impeller, backflushed everything, blew air through the water line from side of block to water gauge, ran motor, water is going through water line. I am wondering if the gauge is shot.

 

[Tony]

Does the guage needle move at all?

 

[Chris]

Connect the gauge to a small regulator, then turn up the air. I have one I use for my airbrush- has a fine-gradient gauge on it and will adjust by 1/2 lb increments. Something like that will do just fine.

 

[Airpacker]

New impeller, backflushed everything, blew air through the water line from side of block to water gauge, ran motor, water is going through water line. I am wondering if the gauge is shot.

water is going thru the water line? What do you mean by thru? water may travel up the PRESSURE line a little but it shouldn't make it to the gauge head by any means. If it does, you got a bad gauge.

 

[dykstra]

Does the guage needle move at all?

no

 

[dykstra]

water is going thru the water line? What do you mean by thru? water may travel up the PRESSURE line a little but it shouldn't make it to the gauge head by any means. If it does, you got a bad gauge.

water IS traveling to gauge.

 

[DAREDEVIL]

water IS traveling to gauge.

if the needle does not move ,,its shot !

 

[dykstra]

Thanks for all the replies everyone!

 

[Holy Smokes]

Check to make sure it's getting 12V when the ignition is on. If the needle won't jump it would be either no ignition or bad gauge.