project baron

motor1.jpghere is a shot of the motor lined up, i wanted to get it mounted but i had a hard time finding alum angle for the mounts, so i guess it well wait until spring.

todd
 
here is one more of the access holes cut for the new motor mount in the front. wish i would have waited to put the floor in.

todd
 

Attachments

  • motor2.jpg
    motor2.jpg
    55.7 KB · Views: 8
and the last one from from saturday off to the glass shop for the last time, yea baby the end is near.

todd
 

Attachments

  • motor3.jpg
    motor3.jpg
    46.3 KB · Views: 10
hey paul. 4' of 3/8 x2"x2". i could go a little larger, could not find any on a short notice. i will find some over the winter and get it going in the spring. time to get going on the cig. which i sent 5 hours sunday taking apart.

todd

todd
 
What's your plan on the Cig????


Go faster than Dan?????:sifone:

way to much, motors are out, a few bulkheads in the cabin, regel the bilge, borrow your props again, and the list goes on. and on that beat dan thing, well maybe down the highway. lol. or in the dux's.

todd
 
Todd that person if memory serves me right raised is X dimension on is 185 - XLT rather X- Treme, and when we talked over the phone i am thinking it was over 6 inches or more thus the reason , and if i could remember his screen name i would personally shoot him a P M . Thanks artie
 
Back
Top