Distributor / coil?

[SickSation]

What distributor/ coil are you guys running? Got a 540 N/A.

 

[bajabob 718]

msd

 

[SickSation]

msd

.
6al blaster 2 and #85551 coil a good combo? Worth the money?

 

[SickSation]

.........

http://www.jegs.com/i/MSD-Ignition/121/85551K/10002/-1


I can get this setup for under 400.00

 

[fever 38]

msd also. tried hard to run the stock but it didnt happen. just get the msd and be done.:banghead:

 

[SickSation]

msd also. tried hard to run the stock but it didnt happen. just get the msd and be done.:banghead:

what problems did you run into with the stock setup?

 

[fever 38]

timing would stary to retard @ about 5000 rpm then hit rev limiter at 5200. set timing at 32 deg @ 3000 that put base timing at 8 deg. black soot on transome and loaded plugs . now better timing curves,base time about 18. better idle and cleaner running motors.ps i also tried to keep the mec fuel pumps , didnt work just get the electrics and be done. good luck. brian :cheers2:

 

[SickSation]

timing would stary to retard @ about 5000 rpm then hit rev limiter at 5200. set timing at 32 deg @ 3000 that put base timing at 8 deg. black soot on transome and loaded plugs . now better timing curves,base time about 18. better idle and cleaner running motors.ps i also tried to keep the mec fuel pumps , didnt work just get the electrics and be done. good luck. brian :cheers2:

hmm... I still have thunderbolt IV. I have a 22' advance, but it only advances 18' at 3000 rpm. Ive got black soot on transom bad. Ill be gettin an MSD today. I just put on a mech 110 gph holley. I guess i should go ahead and swap to electric as well. Thanks for the heads up man. Ian

 

[fever 38]

any time. put a fuel psi gauge on and you might be able to keep the mec pump. i held 6 lbs till the 2ndaires pulled open then psi went to 3 lbs. you want a min of 5 max at 8. good luck . ps i used the lightest springs and the largest bushing on my msd.

 

[SickSation]

any time. put a fuel psi gauge on and you might be able to keep the mec pump. i held 6 lbs till the 2ndaires pulled open then psi went to 3 lbs. you want a min of 5 max at 8. good luck . ps i used the lightest springs and the largest bushing on my msd.

Got almost 9psi at idle. Havent ran it this week, but i will keep an eye on it next time i run it.

 

[rockfish71]

Dont waste your money on msd.... if you do buy msd buy a spare module you will need it!
Here is a better system and won't leave you hang in..
http://www.performancedistributors.com/marinedui.htm