Recent content by Throttle Fever

Props are sold>>>>>>> Please delete post...

Have a right and a left. $500.00 for the pair. Will not split, sorry. Will post pic's if there is any interest.

Didn't they have a rubber washer that went on the bolt on the outside?

Sent you the info. Pete

Answering any Pm's?

Rustoleum does a great job. Looks good.........

White looks great, but make sure you clean or bead blast every weld and nook and cranny. Painted one of my old trailers white, but must have missed a weld or two in the prep. Had a couple rust spots come thru after a couple of years. Rust on white paint sure shows up. Pete

Have two sets (four risers). They are modified to a dry configuration. They have 3/8" tubes tig'd into the lower part of the water jacket for drains (can be trimed to fit what you have). Also have 3/4" bungs tig'd on, to exit the water over board. They worked great. They are in great shape...

Pm you this afternoon. Thanks

Got It Showed up today. Nice. Will put it to good use. Thanks Again.........:cheers2:

How about venting some of the engine compartment heat to the helm station. Did that on a older boat I owned (twin setup) via a blower fan. It was not the hottest air but it took the chill away. Pete

PM Sent Thanks Pete Checks in the mail.............

Second offer..

$80.00 shipped? Thats what J&R sells them for.

Yes sir. That what it sounds like to me. Would order a .005 and give a try. If still sloppy the .010. Look at the bottom of your main caps (the surface were they mount to the block) usually you can tell if it has been been machined by a rough cut surfacing job or look. Factory caps are pretty...