Recent content by STOMPER

maybe i will stop down there tomorrow and see what they can do for me. i just talked to Mike Bender and he said he can do the heads for me rather quickly. Bob Madara from marine Kinetics is putting together a cam, valves, springs package right now and the only thing left is to find out who can...

Pro1 - is Doc still there along with Ronny?

Have you read OSO under beware? We have a machine shop in Westwood NJ we use who is pretty good. He does about 300 motors per year. Pro1 - you talking about R&L Engines? i used to work there for 2 years when i was 18 and 19 years old. when barry owned it. i working in the head dept. i was going...

Well here is what shut me down for the weekend (see photos), two pieces of an intake valve on cylinder #6. found the smaller piece in Cylinder #1 and the larger piece stayed in 6. i bought the engine from someone off Team Baja Marine and it was fresh out of Merkel Race Engines in L.I., but guess...

thanks anthony, i was also thinking about LRB performance in Franklin. i am going to call him in a few.

Nordic - no good. was not the drive. either lost a rod cap, or ate a piston. yanking the engine out tomorrow. spark plug was hit pretty good, did not drop a valve, so it was something in the cylinder. either it ate up a piston or just lost a cap. praying nothing more happened and it is a easy...

well i do not think i will be making it this upcoming weekend. took the boat out today and i am pretty sure i wasted the Bravo 1 Outdrive. could not get it on the trailer since it was way to windy and would have been a hard time towing it into the ramp. so for now i have it tied up in a slip.

nordic, i am going to try wand get the boat in tomorrow after the rain and leave it at my marina. the thing sounds awesome, hopefully it will run as good as it does on the hose in the water. just spent over 3,000 on carb and fuel system, so hopefullly it runs what i am expecting out of it...

ok, i know your old boat. well i got the carb on, working on the linkage and fuel syste now. do not know if i will get it in the water tonight, tomorrow going to rain and be really windy. so sunday is my best shoot at tuning. still going to be windy, but that makes for good flying weather...

you talking about the sweet 16 donzi that the older guy has?

forgot to reply to thee leaving G.L./warwick area question and was going to ask the same thing. last weekend i ran over to Stony Point to check the area out again, but the GPS brought me through the park. not sure what is the best way to go with towing the boat. any routes traveled before would...

sounds good. i will hope to get the fuel system and carb on today so i can put stomper in the water today as well for a test run. what boat did you have last year? you had to have seen me out there last year. i included a few pics on the boat, one with it on the trailer, motor shot and one...

yeah, richie has the 28' sunsation. your buddy is the guy with the 20' ciig that just had some motor work done last year at willow? lives on the lake across from willow? i remember rick (mechanic from willow) working on a older cig. putting new heads on it. anyway, we are always there, so stop...

Nordic / Matty, where you guys located? and what boats are you running? we dock at willow point marina. there is about 10 of us over there, but only two performance boats, my Baja and my buddies 28 Sunsation. we are there pretty much all weekend in the summer. stop in anytime. we have a big...

well i am just waiting on my BIGS Performance carb to show up this week and new fuel system from Summit. hopefully it is all here this week so i can get a weekend to tune it on the lake. the boat was going to the paint booth next week, but i might delay it so i can do the run. i cannot stand...