Recent content by sterling

Thanks guys ,I just got back from holiday in Malta ,I got 2 more weeks now ,and the weather is going to be good here ,so hopefully I,m going to look if the smaller diameter will help spinning up the engine rpm,s .

http://youtu.be/ci3LIS4f2Fw

I have a video made by a friend that was on the water were we tested the boat ,I need to find out how to upload it here . This is the first time the boat was in the water ,I ran the engines while the boat was still sitting on the trailer for 10 min each ,and tested the transmissions in forward...

more

in the water first time

Unfortunatly I didn,t do much work on the boat ... I really don,t know how to find the time to finish the last things ,I think I,m going to put her in the water next month whether she,s ready or not ,and see if it all works as planned . I will make a video and post here Grtz A.J

I didn,t do much work the last months ,I ,m going to post some pics from the work I did ,it is not too much work to finish the boat ,only some cushions in front ,and the stereo . Too busy with work .... Thanks A.J

Its coming along slowly ,I,m busy with the shower and all the hoses , had to buy a pump unit ,to collect all the water from the shower ,so it can be pumped out overboard ,since the drain is so low I had to pump it up aprox 1 feet to dump that water through a thru hull . snap in carpet is ready...

Thanks Ratickle ,No need to call for help,as it was pretty easy fix ,the new seal is in the port transmission ,and filled up with oil ,and so far no leaking ,gonna check tomorrow ,and next saturday when we are going to run on the hose again to see if the trannies shifting in first and second...

Who,s Pat ? is that a ZF guy ?

Bad luck ... I found both transmissions are leaking oil throught the seal on the outputshaft mm I looked under the trannies with a mirror and flashlight to see if they were leaking somewhere else ,but it was all dry ,exept the seal on the outputshaft ,so I took one seal out ,and ordered 2 new...

You ,re right ,I,am going to finish this project first , today I did some work in the dash ,most wiring is done ,but I had 1 rpm gauge not working ,and found a loose wire at the hall sensor in the flywheel housing . Now rpm gauge works fine , all connectors at 2 speed module are connected ,and...

Thanks ,and yeah I,m also very glad it is finally coming together,I like to start with something else now ... probably big big power in the HTM..

Thanks Ratickle ! We do our best ,yesterday we fired both engines up on the hose , to find out if there are any gremlins showing up ,the engines were running fine ,both ZF gearboxes were shifting fine ,I could not let them shift 1 th gear because that wiring is not finished (gearbox is in 2 th...

Some pics from upholstery been done in the last weeks.