Recent content by Sledge Hammer

You could have a builder like Ateco put together a 540 for less money, and it would be considerably faster.

Are you sure that last dyno sheet is for your motor? If you page to the bottom it says it has a 4.030 bore, 3.385 stroke, 5.7 rods and 12.7 to 1 compression ratio. Sounds more like a small block. It is not a 540. Perhaps the data on the bottom of the sheet is not for your engine, but then I...

I guess I go in a different direction on this one. I get a pile of satisfaction out of the modifications and the fact that my boat is a lot more than one or two MPH from everyone elses out there. I am running a Baja Hammer with a 610 HP 540 at 85 MPH on the GPS. I have put more money into the...