Recent content by morepower

So Ratickle what should be the procedure. I hear you Bouy.

I can't leave it like that, would never be happy with it. Hmmmmmmmmmmmm Where do I start.

Okay Artie, the boat is gel. Am I doing this myself depends on how much you would charge me LOL. How complex of a job is it and what would I expect to pay for it. I don't have a problem buying the tools but I don't want to get over my head. Can you tell me the steps. Thanks Bryan

on what to do at this point in time really depends on you ,and just curious how big of a gap is between the hull and the straight edge and to be honest with out sounding rude if this was my boat or a customer's ............ most likely it would be addressed at this time . Ginger, depends on...

Try the pictures again. The hull is basically complete. He put the composite on the hull then the transom then glassed hull and transom. I put the stringers in last week not knowing of the waves, started moving my bunks to sit properly on the trailer and oh sh!!. I really don't know what to do...

Don't know if you can see them. Boat is a 24' Python and goes 70. I don't know what he used but at this point it's moot, I would assume all he did was grind it. I just put my stringers in and was adjusting my bunks when I noticed it. I have it upside down to fix a stress crack and to sand the...

Had a fiberglass man redo my hull with composite and it has waves in the hull going from front to back starting where the hull makes the transition to going flat . Do I need to redo it. The waves are about a foot apart and about 1/16" to 1/8"from top off wave to the valley and travels about a 6'...

Yes bought it new in 89 and its been sitting up for the last 10 years, didn't know if I wanted to take on the project because it was so big. But decided to and I'm going with composite don't want any more root and it's light weight, should be able to post tomorrow.

I was looking at the Bomar hatches, if I can't find these that's what I'll do. As for the build quality mine was on the lacking end numerous problems. I sent it to him for chine repair and got it back with bondo and stole my stereo and hatch lift. Drilled drain holes and didn't seal them. I'm to...

Thanks for the welcome. Don't know if I did it right. It is a 1989 24 Vector/ Python, no longer in business. I am doing a total restore to the boat and have the cap off of the hull with the cap upside down so can't show what it looks like on the boat. The guy went under around 95 and if I'm not...

Anyone knows who makes the deck hatches on a 24 Python. Thanks