Recent content by dschroe2

Here is some places that helped; http://www.dragstuff.com/forum/viewtopic.php?t=2447 - This is a forum that tells you the modules start cutting out cylinder 200-300 RPM early. It also tells you the Ohm reading up to 9400 RPMs if you want to build your own module!

I went on a search on the internet and finally found them on Huntington Bach, Ca. http://www.piersideparts.net/ , this is surprising as they are mainly a Volkswagon parts supplier. And the good news is it sounds like they had more! The parts arrived today and they are just what I wanted so I...

Msd/ Holley were no help. He had some chips 5400 and 5800. To low! I then went to the internet and searched on MSD's part #87466 and started calling. I found one place in Australia that had 2, but they don't ship overseas. I then found "Pierside Parts" in Hunington Beach Ca, and they had...

Not an option for a solid roller, if the prop comes out of the water the engine can spin up to 8000 or more RPM in a heartbeat. Without a load on the engine you are playing with dynamite with the fuse lit!

Just checked out Teague, they show the picture of the kit that MSD use to sell, but under the picture is nothing.. MSD made the kit for a short time and now they don't. The kit was 6200-7000 in 200 RPM increments. Holley states that the 6000 chip should be good to +/- 50 RPM, but on the...

I am looking for a 6200 - 6600 RPM chip for the MSD 6M-2L box. I currently run a 565 BB with a mechanical roller. My peak horsepower is at 5900 RPM and MSD's 6000 chip starts knocking out cylinders at 5700. So I am looking for a bigger chip if someone has one the don't use. As I say it can be...